Xycd60 Manual ^new^ Site

Detailed Product Guide and Manual: XYCD-60 Dual-Output Temperature Controller

The device supports UART communication for remote monitoring and parameter setting (e.g., Baud rate 9600). Calibration: xycd60 manual

The relay closes when the voltage falls below a set lower limit ( ) and opens when it reaches the upper limit ( cap U cap P ) to prevent overcharging. Discharging Mode (dn): Battery Installation: Slide open the battery cover on

Error Handling: If "ERR" flashes, it indicates the lower limit (dn) is set higher than the upper limit (UP). Safety and Installation Notes xycd60 manual

4. Parameter Settings

To change the target temperature or calibration settings, follow this standard procedure:

Before using the Xycd60, please read and follow these safety precautions:

Initial Setup (Missing from many XYCD60 manuals)

1. Battery Installation: Slide open the battery cover on the back. Insert the LR44 battery with the positive (+) side facing up. If the screen is flickering or dim, flip the battery – polarity confusion is common.
2. Power On: Press the ON/OFF button. A reading should appear. If it reads "0.00" or "0.000", you are ready.
3. Jaw Cleaning: Before use, close the jaws fully and wipe them with a clean cloth. The XYCD60 manual often fails to mention that dust or oil can cause zero errors.