V2000-c Rfid Access Control User Manual -

The V2000-C RFID Access Control is a standalone, single-door system supporting card-only, PIN-only, and card+PIN authentication modes with up to 2,000 user capacity. Key features include a Wiegand 26 interface, Tamper alarms, adjustable door delay, and compatibility with 125KHz EM cards. For more detailed technical specifications, visit goldbridgesz.com www.goldbridgesz.com

Part 9: Frequently Asked Questions (FAQ)

Q: Can the V2000-c work with a smartphone app? A: No, the V2000-c is a standalone controller. It does not have WiFi, Bluetooth, or Ethernet. For remote access, pair it with a separate network-enabled relay. V2000-c Rfid Access Control User Manual

The V2000-C RFID Access Control system is a standalone device supporting up to 2,000 users with card-only, PIN-only, or combined verification modes for single-door security. It features a stainless steel design, 12V DC power requirements, and supports Wiegand 26-bit interfacing for integration. Detailed instructions for installation and user enrollment can be found in the savebase.com manual www.goldbridgesz.com The V2000-C RFID Access Control is a standalone,

Continuous Beeping: This usually indicates the "Tamper Alarm" has been triggered. Ensure the back cover is securely fastened. Set date/time (required for accurate logs)

  • Set date/time (required for accurate logs).
  • Enroll an admin card:
  • Set lock relay pulse time (e.g., 1–5 seconds) and alarm durations.
  • Add user credentials: enroll cards/fobs by presenting them in enrollment mode; assign IDs, access schedules, and group membership as supported.
  • Configure door sensor behavior: alarm if forced open or propped open beyond allowed time.
  • Enable/disable keypad tones, LEDs, and buzzer volume per site preference.

    • Forgot Master Code: Power off the device. Press and hold the # key (or the reset button inside the housing) while powering back on. The device will beep, and the Master Code will revert to the factory default.

    User Management

    • Add user: In programming mode choose Add → present card → assign ID/name/group.
    • Delete user: Select Delete → present card or enter user ID.
    • Batch import/export: Use PC software where supported (CSV or proprietary export).
    • Access levels: Create schedules (time zones) and group users into access groups to restrict by time/day.

    5. Programming Instructions

    All commands must be entered via the keypad, followed by the # key unless noted.