Usb Device Id Vid 1e3d Pid 198a < Top 100 Top-Rated >

USB Device ID Vid 1e3d Pid 198a refers to a generic flash drive powered by a Chipsbank Microelectronics controller. DeviceHunt Here is the "story" of this device: The Manufacturer The Vendor ID (VID) belongs to Chipsbank Microelectronics Co., Ltd.

USB Flash Drive Speed Tests - VID = 1e3d, PID = 198a - NirSoft Usb Device Id Vid 1e3d Pid 198a

Example commands

• Linux: list devices

  5. Hardware Failure (Bad Capacitor or Crystal Oscillator)

  The 12 MHz or 24 MHz crystal oscillator on the flash drive’s PCB may drift off frequency. In this case, the USB host controller can still read the basic VID/PID (low-speed negotiation), but high-speed mass-storage mode fails. USB Device ID Vid 1e3d Pid 198a refers

  Solution: Try shifting the drive to a rear motherboard USB port. If it still fails to read, the device may need to be put into "Test Mode" by manually shorting specific pins on the controller circuit board. 💾 Firmware & Recovery Tools Linux: list devices 5

  The Product ID (PID) 198A falls within a range of devices typically associated with embedded microcontroller units (MCUs) or capacitive touch/temperature sensor interfaces. However, based on aggregated driver logs and hardware databases, this specific PID is most commonly identified as:

  Short paper: "USB Device ID VID: 1E3D PID: 198A — Identification, possible vendor, and investigative steps"

  Abstract This note summarizes publicly available methods for identifying a USB device with Vendor ID (VID) 0x1E3D and Product ID (PID) 0x198A, discusses likely device types given those identifiers, and provides practical steps for further investigation and secure handling.

  Step 2: Uninstall and Reinstall the Device in Device Manager

  1. Press Win + X and select Device Manager.
  2. Scroll down to Universal Serial Bus controllers.
  3. Look for any entry with a yellow exclamation, especially “Unknown USB Device” or “Mass Storage Device.”
  4. Right-click the problematic device and select Uninstall device.
  5. In the confirmation dialog, check “Delete the driver software for this device” (if available).
  6. After uninstall, click Action > Scan for hardware changes.
  7. Windows will attempt to reinstall the generic USB mass-storage driver.

  Vendor ID (VID): 1E3D
  Product ID (PID): 198A