Mpu6050 Library | For Proteus

Integrating an MPU6050 into Proteus is a common challenge because the software does not always include the sensor in its default library. To simulate it, you must manually add the Proteus library files and use a corresponding Arduino library for the code. 1. Adding the MPU6050 Library to Proteus Since Proteus often lacks a built-in model for the Go to product viewer dialog for this item.

1. Place a 24LC256 EEPROM (I²C) in Proteus.
2. Configure its I²C address to 0x68 (MPU6050 default) or 0x69.
3. Preload the EEPROM with dummy sensor data at register addresses (e.g., store 0x12 at 0x3B, 0x34 at 0x3C, etc.).
4. Connect your microcontroller (e.g., PIC, AVR, Arduino) to the same I²C bus.
5. Write firmware that reads from these addresses as if reading an MPU6050.

Step 1: Locate the Proteus Library Folder

The default paths are:

// Read MPU6050 acceleration data signed short accel_x; i2c_start(); i2c_write(MPU6050_I2C_ADDRESS << 1); i2c_write(MPU6050_ACCEL_XOUT_H); i2c_rep_start(); i2c_write((MPU6050_I2C_ADDRESS << 1)