K150 Pic Programmer Software Windows 10 May 2026

The K150 is a popular, low-cost PIC programmer that supports various Microchip PIC microcontrollers from the 10, 12, 16, and 18 series. While widely used, setting it up on Windows 10 requires specific attention to drivers and software configuration. Programming Software: Microbrn The primary software for the K150 is Microbrn.exe.

While the K150 PIC programmer software is compatible with Windows 10, some users have reported issues with the software not working properly. The most common issues include: k150 pic programmer software windows 10

1. Hold Shift and click Restart.
2. Go to Troubleshoot → Advanced Options → Startup Settings → Restart.
3. Press 7 or F7 for “Disable driver signature enforcement.”
4. Install the driver from the CD using have disk method in Device Manager.

• Put the chip in the ZIF socket (check the diagram on the programmer for pin orientation).
• Click Write.
• If successful, you will see a progress bar and a "Verify OK" message.

• PICPGM (comes with many K150 clones): Open the software, select the correct COM port (the same one from Device Manager). Set speed to 9600 or 19200 baud (experiment if needed). Select your PIC chip model.
• WinPIC800 (more powerful): Under Settings → Interface, choose "JDM Programmer" or "K150" (if listed). Manually set COM port. Note: WinPIC800 often works better than PICPGM on Windows 10.

Alex plugged the PIC into a breadboard with an LED and resistor. Applied 5V. The LED blinked! Windows 10 had been conquered. The K150 is a popular, low-cost PIC programmer

The "K150 Hack": A detailed technical breakdown by Eric M. Klaus explains the electronics of the programmer and how to bypass troublesome USB chips entirely using a TTL serial signal . Hold Shift and click Restart

1. Select the PIC microcontroller device from the supported devices list.
2. Load the.hex file or source code file to be programmed.
3. Configure the programming options (e.g., oscillator frequency, programming mode).
4. Program the PIC microcontroller by clicking the "Program" button.
5. Verify the programmed device by reading its memory contents.

The K150 PIC programmer is a budget-friendly, effective tool for hobbyists, though it requires specific setup to work reliably on Windows 10. While highly affordable, its reliance on older USB-to-serial chips often presents driver challenges on modern systems. Compatibility & Features