Warning: Before proceeding, ensure you have a good understanding of the risks involved in IMEI repair and the use of Sigma software. Improper use can lead to device damage or permanent loss of warranty.

Required Tools and Files:

The software will send the bootloader files. Once finished, the phone will enter a specialized service mode. IMEI Repair Switch to the IMEI / Repair tab.

IMEI Changing: In many countries, changing an IMEI number is illegal. Ensure you are only repairing the original IMEI to restore device functionality.

Step 5: IMEI Repair

Phase 1: Entering Factory Diagnostic Mode

  1. Power off the JNY-LX1 completely.
  2. Open the back cover (heating gun and plastic picks required).
  3. Disconnect the battery flex cable for safety.
  4. Locate the Test Point (TP). On the JNY-LX1 board, it is typically near the SIM card tray pins.
  5. Short the TP to ground using tweezers.
  6. Connect the USB cable to your PC while maintaining the short.
  7. Release the short after 3 seconds.
  8. In Windows Device Manager, you should see "Huawei USB COM 1.0" (Port X). This is the "download mode" required for Sigma.

Before starting, ensure you have the following tools and environment ready:

To perform service operations on the Kirin 810 chipset inside the JNY-LX1, you must put the device into Huawei USB COM 1.0 mode. Power off the device. Open the back cover carefully.

Jny-lx1 Imei Repair Sigma 🎯 Confirmed

Warning: Before proceeding, ensure you have a good understanding of the risks involved in IMEI repair and the use of Sigma software. Improper use can lead to device damage or permanent loss of warranty.

Required Tools and Files:

The software will send the bootloader files. Once finished, the phone will enter a specialized service mode. IMEI Repair Switch to the IMEI / Repair tab. jny-lx1 imei repair sigma

IMEI Changing: In many countries, changing an IMEI number is illegal. Ensure you are only repairing the original IMEI to restore device functionality. Warning: Before proceeding, ensure you have a good

Step 5: IMEI Repair

Phase 1: Entering Factory Diagnostic Mode

  1. Power off the JNY-LX1 completely.
  2. Open the back cover (heating gun and plastic picks required).
  3. Disconnect the battery flex cable for safety.
  4. Locate the Test Point (TP). On the JNY-LX1 board, it is typically near the SIM card tray pins.
  5. Short the TP to ground using tweezers.
  6. Connect the USB cable to your PC while maintaining the short.
  7. Release the short after 3 seconds.
  8. In Windows Device Manager, you should see "Huawei USB COM 1.0" (Port X). This is the "download mode" required for Sigma.

Before starting, ensure you have the following tools and environment ready: Power off the JNY-LX1 completely

To perform service operations on the Kirin 810 chipset inside the JNY-LX1, you must put the device into Huawei USB COM 1.0 mode. Power off the device. Open the back cover carefully.

Promo ×