!!hot!! | Id6100 Danieli Manual Hot
The Danieli Automation ID6100 is an infrared hot metal detector and loop scanner specifically engineered for harsh industrial environments, such as hot rolling mills. It is used as a loop position detector between two mill stands to track the position of hot material. Overview of the Danieli ID6100
Danieli Automation ID6100 is a discontinued infrared loop scanner and metal detector specifically designed for the extreme conditions of hot rolling mills id6100 danieli manual hot
- Contact Danieli Service & Support directly via their official website.
- If you’re an existing customer, request access to the Danieli Customer Portal where manuals like ID6100 (likely for a Hot Strip Mill, QSP, or EAF automation system) are available in PDF.
- If the bar loops up between stands: Increase downstream speed OR decrease upstream speed.
- If the bar pulls tight (stretches): Decrease downstream speed OR increase upstream speed.
Error 09: Bus Communication Timeout
- Cause: Electromagnetic interference from a nearby induction heater (common in hot rolling).
- Solution: Check the shield grounding of the Profibus/Profinet connector. The manual specifies grounding only on the CPU side, not the module side.
Disclaimer: This article is for educational purposes. Danieli is a registered trademark of Danieli & C. Officine Meccaniche S.p.A. Always consult official OEM documentation before modifying industrial control systems. The Danieli Automation ID6100 is an infrared hot
. While Danieli has moved to newer generations like the ID6000 or ID2400 series, the ID6100 remains widely available through industrial surplus and repair specialists like Radwell International MRO Global Solutions wiring diagram for this specific model or a comparison with the newer Contact Danieli Service & Support directly via their
Why the "ID6100 Danieli Manual Hot" is Critical for Mill Technicians
When you search for this manual, you are likely facing one of three emergency scenarios:
