Harvey Hv3 Water Softener Installation Manual !link! Page

Installing a Harvey HV3 water softener involves connecting the unit to the main water supply, typically under the kitchen sink or in a utility space, following WRAS-approved procedures and maintaining water pressure between 1.7 and 6.0 bar. The process requires a three-valve bypass, proper drainage with an air gap, a 5-liter initial water charge, and the use of block salt. For the full installation manual, visit Harveys water softener installation manual

Pull the red battery tab to activate the sensor and hold down the sync button until the blue light flashes to pair with your local WiFi. 🚀 Commissioning and Testing harvey hv3 water softener installation manual

Harvey HV3 is a non-electric, twin-tank water softener designed for block salt use. Installing this unit involves four primary connections—inlet, outlet, drain, and overflow—and requires adherence to local plumbing regulations and WRAS guidelines Pre-Installation Requirements WATER SOFTENER INSTALLATION GUIDE Installing a Harvey HV3 water softener involves connecting

Part 6: Maintenance Schedule – Following the Manual’s Advice

The manual is clear: the HV3 is low-maintenance, but not no-maintenance. If control valve requires power, plug into a

Water Pressure: Must be between 1.7 bar and 6 bar. If pressure exceeds 6 bar, install a pressure limiting valve to prevent damage.

Electrical

• If control valve requires power, plug into a properly grounded outlet. For battery-backed models, install batteries per manufacturer instructions. Avoid extension cords.