--- Epcos Power Factor Controller Br 5016 Manual Pdf ^hot^ May 2026

The Epcos Power Factor Controller BR 5016 is a high-precision, microprocessor-based control device designed for Automatic Power Factor Correction (APFC) in industrial electrical networks. It is specifically engineered to handle unbalanced three-phase loading conditions by utilizing 3-CT (current transformer) sensing, ensuring stable and efficient power factor correction even in complex grids. Core Technical Specifications

Phase 3: Set CT Ratio & Voltage

3 Pole Epcos BR5016 APFC Relay Price & Specifications - Aajjo --- Epcos Power Factor Controller Br 5016 Manual Pdf

Switching Steps: 16 relay outputs (normally open contacts) for 3-phase capacitor branches.

Disclaimer: This article is a user-generated guide and reference. Always refer to the official EPCOS/TDK BR 5016 manual for site-specific safety regulations and electrical codes. De-energize all circuits before installing or servicing power factor correction equipment. The Epcos Power Factor Controller BR 5016 is

Epcos Power Factor Controller Br 5016 Overview

If you cannot find the manual through the official TDK site, try searching specifically for "Epcos BR 5000 Operating Instructions" as this covers the entire range, including the 5016. Mounting: Install the controller in the switchgear cabinet

Protection: Includes warnings for over/under voltage, over/under frequency, and capacitor over/under current.

Mounting: Install the controller in the switchgear cabinet using the standard DIN rail or cutout mounting provided.
Voltage Connection: Connect the voltage reference (usually L1 and L2/N) to the designated terminals.
Current Transformer: Connect the secondary side of your Current Transformer (CT) to the measurement inputs. Crucial: Ensure the CT polarity (S1/k, S2/l) is correct.
Outputs: Connect the capacitor contactor coils to the relay outputs on the controller.
Auto-Setup: The BR 5016 features an automatic setup mode. Once powered, you can initiate the auto-sensing sequence, where the controller identifies the connected capacitor steps and calculates the required C/k values automatically.