E2h Datasheet !full! | Dc
The code DC=E2H typically refers to a specific product marking used for the RT9193-18GB or TX6211B-18 Low Dropout (LDO) linear regulators, specifically the 1.8V output variants in a SOT23-5 package. Product Identification
: 1.8V (indicated by the "18" in the part number and "DC=E2H" code). Maximum Output Current : Typically 400mA to 500mA. Dropout Voltage : Very low, approximately 170mV to 200mV at 200mA load. Quiescent Current : Low power consumption, typically 30μA. Standby Current : Less than 1μA when in shutdown mode. Operating Temperature : -40°C to +85°C. STM32-base project Pin Configuration (SOT-23-5) The typical pinout for these LDO regulators includes: STM32-base project : Power supply input. : Ground connection. : Active-high enable pin. dc e2h datasheet
- Input Voltage Range: 4.5V – 5.5V (5V nominal).
- Output Load Range: 10% to 100% of rated load (e.g., 100mA to 1000mA for a 1W module).
- Capacitive Load Max: 100µF (too much capacitance can cause startup issues).
- Look for a logo, full top marking, and any other alphanumeric codes.
- Example: If written as
DCE2HorDC-E2H, search that exactly.
Elias pointed to the Safety & Compliance section. "Over-voltage, over-current, and short-circuit protection are all hardware-level. But look at the MTBF (Mean Time Between Failures)." The code DC=E2H typically refers to a specific
Step 4: Thermal verification.
Ambient temperature: 60°C. Load: 100mA. Datasheet derating curve: At 60°C, you can use 100% load. Safe. Input Voltage Range: 4