Arminius Revolver Manual Of Arms May 2026
Arminius Revolver Manual of Arms: A Comprehensive Guide
Unload: To extract empty cases or live rounds, open the cylinder and push the ejector rod toward the rear of the gun. Firing Modes Arminius Revolver Manual Of Arms
- Ensure unloaded.
- Wipe exterior with lightly oiled cloth to prevent rust.
- Clean bore with proper-caliber brush/patches and solvent; dry and lightly oil bore.
- Clean cylinder face and chambers; remove carbon and lead fouling.
- Lubricate hinge, ejector rod, cylinder rotation point, and hammer/trigger pivot lightly—avoid over-lubrication (can attract debris).
- Inspect timing, cylinder lockup, and screws; torque per manufacturer spec if available.
- Single Action (SA): Manually cock the hammer. The cylinder indexes. Warning: The trigger pull is often less than 3 lbs. Do not touch the trigger until on target.
- Double Action (DA): Just pull the trigger. The hammer rises and falls. Warning: The DA pull is heavy (10-14 lbs). Do not stage the trigger; pull straight through.
- Assume it is loaded: Arminius revolvers have a hammer block safety, but early models (pre-1968) lack a transfer bar.
- The Six-Click Rule: When manually cocking the hammer, you will hear six distinct clicks. The 4th click is the cylinder lock. The 6th click is full cock.
- Drop Safety: Unlike a Ruger, an old Arminius can fire if dropped on the hammer if the hammer block is worn. Never carry a round under the hammer of a vintage model.
Muzzle Awareness: Always keep the muzzle pointed in a safe direction. Arminius Revolver Manual of Arms: A Comprehensive Guide
Lubrication: Apply a light drop of gun oil to the cylinder crane hinge and the hammer pivot point. Ensure unloaded
- Know your variant: Safety bar or no safety bar?
- Load accordingly: 5 rounds (empty under hammer) or 6 rounds (safety on).
- Never dry fire.
- Use the manual sweep: Train your thumb to find the left-side safety lever instinctively.
- Inspect for flame cutting: After 500 rounds, check the top-strap above the cylinder gap for erosion.
The Swing-Out Cylinder: Most modern Arminius variants utilize a crane-mounted cylinder that swings to the left. This design facilitates easier inspection of the chambers and the barrel bore. General Care and Preservation